Roof Replacement guide
Why Delaware attics ice up at the eaves, what ventilation has to do with it, and what a replacement changes.
Last updated: November 21, 2026
Heat escaping into the attic warms the roof deck and melts the snow above it. The meltwater runs down to the cold eave, refreezes, and builds a dam. Water ponds behind the dam and works under the shingles.
The two levers are attic heat and eave protection. Ventilation works on the first. Full-deck protection at the eaves works on the second.
Air in low, at the soffits, and out high, at the ridge, in matched amounts. That flow keeps the deck closer to outside temperature in winter and moves summer heat out before it cooks the shingles from below.
Blocked soffits, painted-over vents, and exhaust-only setups are common findings at Delaware inspections.
A full replacement is the moment to fix the whole path: intake, exhaust, and eave protection, built in as part of the system rather than added as an afterthought.
Very likely part of one. The inspection checks intake and exhaust and what the imbalance is doing to the deck and shingles.
It reduces the melt cycle that creates them. Eave protection handles the water that still ponds. The system approach uses both.
Yes. A hot attic shortens shingle service life from below. Balanced ventilation is part of why the system is built the way it is.
You started an inspection request.
Pick up where you left off. Your answers are saved on this device.